The HF edge gluer manufacturer will show you: the preparation and glue pot setting before the edge banding machine is turned on

The HF edge gluer manufacturer tells you to perform the following operations before turning on the edge banding machine:

1. Check whether the position of the machine in the work area is correct and level.
2. The manufacturer of HF edge gluer tells you to check whether the upper and lower trimming knives of the trimming machine are tightened correctly.
3. Make sure that there are no damaged or blocked parts.
4. Remove the remaining packaging and tools used for machine installation, and check whether there is any foreign matter remaining.
5. Check whether the power supply and control cables of the machine are damaged, such as cuts, bends, crushes, scratches, etc.
6. The manufacturer of HF edge gluer tells you to check whether the air pipeline and accessories are deformed, scratched, damaged or leaked.
7. If all inspection results are good, turn on the "power switch lock" on the control panel to start the machine.
8. After the machine is started, check whether the emergency stop button on the control panel and trimming unit is working properly.
9. Place the edge banding roll on the carrier reel.
The manufacturer of HF edge gluer tells you the setting of the glue pot of the edge banding machine:
1. Use the glue pot heating temperature regulator on the control panel to set the glue temperature (the approximate range of recommended glue pot temperature setting: high temperature glue 180°C-210°C; medium temperature glue 150°C-190°C). When the "power switch lock" is turned on, the glue pot heating device is also activated at the same time, so the heating temperature of the glue pot must be adjusted first after turning on the machine.
2. The manufacturer of HF edge gluer tells you to add granular glue to the top edge of the glue pot 3 cm.
3. The HF edge gluer manufacturer tells you to wait for the granular glue to melt and reach the set temperature (high temperature glue is recommended, and the set temperature is 190℃).
Warning: The heating temperature of the glue pot has not reached the set temperature, and it is forbidden to start the edge banding machine. When the heating temperature of the glue pot reaches the set value, wait another 10 minutes before starting to operate the glue pot.
4. According to "Machine Adjustment and Setting", insert the edge band into the machine, and adjust the workpiece with glue.