Precautions for using high frequency jointing machine

There are many problems that need to be paid attention to when using high frequency jointing machine. Let's take a look at it in detail.

Notes on using high frequency jointing machine:
1. The operator must be trained to be competent for the job, and non-professional operators cannot operate.
2. Operators must wear work clothes and gloves, and they need to be highly concentrated when working.
3. The upper and lower panels of the high frequency jointing machine and the upper and lower panels of the breaking machine have high frequency high voltage. It is forbidden to open the door during operation to prevent electric shock.
4. High frequency jointing machine is forbidden to work without load. Only after the machine is installed, can press the hot key to heat.
5. The setting values ​​of various regulating valves on the plate: try not to use high pressure to avoid equipment damage.
6. The hydraulic oil in the cylinder should be cleaned, filtered or replaced regularly. If the oil level is not enough, it should be filled up in time.
7. When assembling the wood, 2-3mm thick shims and 2-3mm thick wooden pads must be added in front of the iron pile of the rear cylinder. It is strictly forbidden to use wooden pads thicker than the jigsaw panels to avoid damage to the upper panel. .
8. Impurities and glue residues on the plate must be cleaned regularly, especially iron filings and metal products to prevent the plate from burning.
The above are the precautions for the use of high frequency jointing machine, I hope it can be helpful to everyone.