Efficient & Intelligent High-frequency woodworking machinery, Begin with 1993
Efficient & Intelligent High-frequency woodworking machinery
Shijiazhuang Cangao High Frequency Machinery Co.,Ltd.
Add：China's Hebei Province, Shijiazhuang City, Luquan District, Shan Yin Town, Green Island Economic Development Zone, Castle Peak Road on the 2nd
WeChat Public Address
Copyright (C)2017 Shijiazhuang Cangao High Frequency Machinery Co.,Ltd.
Maintenance guide for high frequency assemble machine for photoframe
high frequency assemble machine for photoframe is a modern wood processing machine with high appearance rate. This type of machine requires attention and maintenance to ensure that the machine will not be damaged and prolong the life of the machine. Next, the editor will take you to understand the maintenance method of high frequency assemble machine for photoframe.
Regular maintenance of the high frequency assemble machine for photoframe can effectively prolong its service life. When using the splicing machine, it must be in good condition at all times, so that the splicing machine can be started at any time and the production efficiency can be effectively improved.
The six safety operation points of high frequency assemble machine for photoframe are as follows:
1. Before starting, check the lubrication and tightening of each part. Adjust the rollers according to the thickness of the board.
2. When leveling the board, the operator should stand on both sides of the machine. Never stand in front of, behind or on top of the machine. The workpiece surface should be kept clean and free of weld metal.
3. When smoothing small or long boards. A board that meets the equipment specifications should be placed in front of the two rolls as a backing board. Place the small or long blocks that need to be flattened on the support plate for flattening. Usually, it should be noted that the end of the support block is not less than 300ram away from the roller, and should not be inclined.
4. The plate to be pressed placed on the bottom plate should be staggered and misaligned, and the distance between the two workpieces should not be less than 100 mm.
5. After the operation, loosen the roller and take out the workpiece and the backing plate.
In order to make the high frequency assemble machine for photoframe run reasonably, not stop due to machine damage in the middle, and not affect safety or operation due to machine component failure, it is also necessary to check the status of each part of the puzzle from time to time to obtain a longer overhaul distance . And when we use the jigsaw, we must carefully maintain the high frequency assemble machine for photoframe.